Classification & Storage / Crushers
When conveyed material needs resizing
Kopar crushers typically act as primary crushers for metallurgical lumps from waste heat boilers, slags, and dusts. They can tolerate a continuous temperature of 300 °C.
Our roll and rotor crushers are suitable for crushing cloddy or lumpy materials. Waste heat boiler slag, dust lumps, and bottom ash are typical materials that need resizing in the process.
Once the material is smaller and finer, it is more easily transported with conveyors. Especially pneumatic conveying requires small-sized particles to order to operate smoothly.
Considering the dew point of handled materia is crucial, and therefore, equipment must often be insulated. Our experience has shown that it is advantageous to use easily removable insulation panels, which are pre-installed already at the factory.
Our crushers are designed to last. A new rotor design guarantees a longer lifespan. The innovative design also facilitates easy maintenance, minimizing production halts when necessary.
You can easily integrate our crushing solutions with our pneumatic or mechanical conveying solutions to maximize your facility’s efficiency and productivity.
Suitable usage cases for crushers
Metallurgical Industry:
Waste Heat Boiler lumps, dust and slag.
Energy & Power Industry:
Multiple usages for several various materials – bottom ash, brown coal, coal, lignite, limestone.
Typical features of Kopar Rotor Crusher
Capacity (t/h)
0–50
Inlet particle size (mm)
300 x 300
Outlet particle size (mm)
12–30
All models have the following options: cooling, heating, insulation.
A new feature with hydraulically openable blades to clear jams.
Typical features of Kopar Roll Crusher
Capacity (t/h)
0–30
Inlet particle size (mm)
30 x 30
Outlet particle size (mm)
< 3
with an adjustable size distribution
All models have the following options: cooling, heating, insulation.
Different crusher for different materials
Combination of crushers for optimal results
A required crushing process may consist of one rotor crusher, a combination of two rotor crushers, a combination of one rotor and one roll crusher or one roll crusher.
Our rotor crushers are designed to process relatively coarse materials, with a maximum inlet size of around 300×300 mm. As the typical crushing ratio is ten at a single stage, the material can be downsized to 12–30 mm.
Rotor crushers for coarse materials
If this size range does not meet your specific needs, you have the flexibility to continue the process either with a finer-bladed rotor crusher or with a roll crusher, depending on the desired final particle size and capacity. The new rotor construction introduces a design that allows for easy blade replacement without requiring the replacement of the entire shaft. This new, modernised, construction also enables the use of materials with higher strength, significantly enhancing the overall durability of the crusher.
Roll crusher for fine materials
With our roll crusher, it is possible to meet the final size distribution down to 100 % < 3 mm, depending on the material and the capacity. It is adjustable for your customized needs.
There are plenty of options on combinations, just get in touch and let’s figure out the most advantageous crushing solution for your process!
Test how Kopar Crushers fit your production plans
You have a challenge that needs solving?
Let us help! Contact us for more information about our products and services.