{"id":5579,"date":"2024-04-10T08:23:55","date_gmt":"2024-04-10T05:23:55","guid":{"rendered":"https:\/\/kopar.fi\/?page_id=5579"},"modified":"2026-06-08T14:17:47","modified_gmt":"2026-06-08T11:17:47","slug":"blower-conveyors","status":"publish","type":"page","link":"https:\/\/kopar.fi\/en\/matalapainekuljetus\/","title":{"rendered":"Diluted phase conveyors"},"content":{"rendered":"
\n\t\n\t\t\"Blower\t<\/picture>\n\t\t
\n\t\t
\n\t\t\t\t\t\t\t

\n\t\t\t\t\tPneumatic conveying \/ Diluted phase conveyors\t\t\t\t<\/p>\n\t\t\t\t

Best solution for high volumes over short distances <\/h1>\t\t<\/div>\n\t<\/div>\n<\/div>\n\n\n
\n
\n
\n
\n

Our blower conveyors are your go-to solution for short-distance conveying, especially when the material is light and powdery.<\/p>\n<\/div>\n\n\n\n

\n
\n\t
Interested? Contact:<\/div>\n\t\t\t\n\t\t\t\"Eero\n\t\t<\/picture>\n\t\t
\n\t\t

Eero Lehtil\u00e4<\/h3>\n\t\t

Director, Technology<\/p>\n\t\t

\n\t\t\teero.lehtila@kopar.fi<\/a>\t\t<\/p>\n\t\t

\n\t\t\t+358 41 5439786<\/a>\t\t<\/p>\n\t<\/div>\n<\/section>\n<\/div>\n<\/div>\n\n\n\n

\n
\n

The operational principle of blower conveying is to pair the conveyor with a rotary valve. The material is dosed at the preferred feeding rate into the conveying pipeline through the rotary valve. <\/p>\n<\/div>\n\n\n\n

\n

The typical pressure for conveying is 0.3-0.5 bar(g). Therefore, you only need a blower instead of a compressor, which makes the system relatively cost-effective. <\/p>\n<\/div>\n\n\n\n

\n

The conveying mode, however, is dilute- or lean-phased, which requires quite a lot of air due to low solid loading ratio (\u00b5 < 5).  <\/p>\n\n\n\n

One possible use case is when lime is injected into a power plant's boiler. <\/p>\n<\/div>\n<\/div>\n<\/div>\n<\/div><\/div>\n\n

\n
\n
\n
\n

Suitable use cases:<\/p>\n\n\n

\n